DISCONTINUED - Kicker 42PXA200.1 200 Watt Mono Class D Car Amplifier
- Single-channel 200 Watt RMS amplifier
- 100 watts RMS x 1 Channels at 1 ohms
- High level input capable with an Auto Turn-On circuit
- Conformal coated circuit board suitable for marine, ATV, side-by-side and motorcycles
- On-board KickEQ™ and Remote CXRC Level Control ready
KICKER Tech
KICKER® PX-Series Amplifiers are full of advanced technology. PX Amplifiers are specially designed to deliver tremendous power in a tiny, weatherproof footprint, all while requiring minimal power from your charging system. Their compact size and efficiency make them perfect for sand-rails, motorcycles, and even jet ski's! With auto turn-on options, built-in crossovers and flexible input styles, KICKER® amps give you the custom sound you need. Add the CXARC Remote Bass Controller to any mono PX amp for adjustable volume, right from the drivers seat.
Unbelievable power in a tiny package!
PX Amplifiers are no strangers to the KICKER® tradition of compact size. With as much as 500 watts of power, the only thing small about these amps is their footprint. Made to fit nearly anywhere, these miniature power plants start at under five inches in total width.
- Whether it's a a car, side-by-sides, motorcycle, or personal water-craft a small amplifier is what you want, but good is it without weatherproofing. The PX-Series amplifiers feature a weatherproof wiring harness, moisture-resistant circuit board and aluminum casing.
Kicker PXA200.1 200 Watt Mono Class D Car Amplifier
- PX Series 200 Watt RMS Single-Channel Class D Amplifier
- Conformal coated circuit board suitable for marine or ATV applications
- Amplifier is ideal for motorcycles and other vehicles where conventional amplifiers will not fit
- Extruded aluminum heat sink design
- Speaker and RCA low level Inputs for easy integration with factory and aftermarket audio systems
- Two turn on modes: DC-offset signal sense turn-on for easy integration to factory audio systems and conventional 12 volt trigger
- Stealth bottom mounted access panel for crossover settings
- LED power (Blue) and protect (Green) indicators
- balanced differential inputs and Fail-Safe Integration Technology eliminate noise from your vehicle's electrical system
- 3-way protection circuitry (thermal, overload, and speaker short protection)
- Dual speaker terminals simplify the hookup of multiple speakers
- Vertical mounting optional
- Heavy duty aluminum alloy heat-sink
- Nickel-plated screw terminals
- CEA-2006 compliant amplifier
- Requires minimum 14 gauge power and ground wiring for installation
- Frequency Response: 25Hz to 120Hz +/- 1.0dB
- Signal to noise ratio: 95 dB
- 2 - Nickel-plated RCA high or low level inputs (150 mV - 10 V)
- Input Sensitivity Low level: 125mV - 5V
- Input Sensitivity High level: 250mV - 10V
- Total Power Output: 200 Watts
- 4-Ohms: 25 Watts x 1
- 2-Ohms: 50 Watts x 1
- 1-Ohms: 100 Watts x 1
- 0.5-Ohms: 200 Watts x 1
- Optional CXRC wired remote bass level control
- KickEQ™ Bass Boost: 0dB or +6 dB at 40 Hz
- Selectable low pass: 60Hz / 80HZ / 100Hz / 120Hz (24dB/octave)
- Subsonic filter: 25 Hz (24 dB/octave)
- Overall Dimensions: 1-9/16" (H) x 4-3/4" (L) x 3-7/16" (W)
- Recommended Fuse: 25 amp
Features:
-
Inputs and Outputs:
-
Max Power Output:
-
RMS Power Output:
- Tone Controls:
-
Built in Crossover:
-
Dimensions:
- Current consumption:
Manufacturer | Kicker |
---|---|
Part Number | 42PXA2001 |
Amplifier Topology Class | Class D |
Number of Channels | 1 Channel |
Total RMS Power at 1 ohm | 100.00 |
Total RMS Power at 2 ohm | 50.00 |
Total RMS Power at 4 ohm | 25.00 |
Total Peak Power Output | 200.00 (Watts) |
Amplifier Bridging | Not Bridgable |
Minimum Impedance in Un-Bridged Mode | 0.5 ohm |
Strappable Amplifier | No |
RCA Pre-amp Audio inputs | 1 Pair |
RCA Pre-amp Audio outputs | 1 Pair |
Preamp voltage | 150 mV - 10 V |
Speaker level inputs | Yes |
Gain Control | Yes |
Bass Knob / Remote Gain | Optional |
Built in Crossover | Low-pass |
Cooling Fan | No |
Color | Black |
Warranty | 2 Years |
Recommended Power Wire Gauge | 8 Gauge |
CEA2006 Compliant | No |
UPC Code | 713034073727 |
Return period | 30 days |
Exchange period | 30 days |